Sonodyne AM41P User Manual

INSTALLATION AND OPERATION MANUALPOWER AMPLIFIER AMD2100P AMD2200P AMD4100P AMD4200PAMD SERIES

Go OnlineThe Go Online dialog is presented when selecting Device/Go Online from the main menu, or when selecting the Go Online button at the bottom le

Third party control is supported via two physical interfaces:1. RS-232 serial port2. Ethernet portThe AMD P Series amplifiers provide third party com

Packet HeaderThe header for each packet is 10 bytes in length and consists of the following: UInt16 ProtocolId = 0x5E03;UInt16 SubType = 0x0001; U

Command: Channel Input Cross Mix Level (PCML) This command is used to get/set the level of an input to an amplifier channel. %PCML:xyzz<CR> Where

Command: Channel Output Level (PLVL) This command is used to get/set the level of an amplifier output channel. %PLVL:xyy<CR> Where x is output ch

Command: Standby Mode (PGRN) This command is used to get/set whether or not the amplifier is in Standby (power-saving) mode. In this mode, the amplifie

Description Command Response Parameter Description Valid Range Value DetailGet Input Cross-Mix Level %PCML:xy??<CR> %PCML=xyzz<CR> x

Description Command Response Parameter Description Valid Range Value DetailSet Output Level %PLVL:xyy<CR> %PLVL=xyy<CR> x Output Chan

CONTROLSIGNAL CLIPFAULTSIGNAL CLIPFAULTSIGNAL CLIPFAULTSIGNAL CLIPFAULTAMD4100PCHANNEL 1 CHANNEL 2 CHANNEL 3 CHANNEL 4INPUT 4ETHERNETVCA 4VCA 3VCA 2V

Specification Conditions Frequency Response 70Hz - 20kHz, ±3 dB Signal Input 2 dB below clip Total Harmonic Distortion < 0.6dB Signal Input 2

1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do not use this apparatus near water.6.

AUSTRALIAN MONITOR Address: 1 Clyde Street, Silverwater, Sydney NSW 2128 Australia. Private Bag 149, Silverwater NSW 1811 ACN 007 573 417 Website: w

The AMD P series of power amplifiers from Australian Monitor represent a quantum leap forward in connectivity, controllability & flexibility in the

1 Signal IndicatorThe signal indicators (blue) illuminates when audio is present on the relevant amplifier channel. 2 Fault IndicatorThe fault indica

1 Mains InputMains input is via a 3-pin IEC socket. A mains cable to suit your region is provided with your Australian Monitor amplifier.The amplifier

UnpackingEvery Australian Monitor product is tested and inspected before leaving our factory and should arrive in perfect condition.When opening the c

Main ScreenThe Main Screen provides an audio matrix for setting up the amplifier input and output relationship, signal level meters and various amplifie

Crossover / EQ The Crossover / EQ block allows the user to enable and adjust crossover and EQ functions for each amplifier output channel.The crossover

Output The output block allows the user to trim the output level of each amplifier channel. Mute and Phase Invert controls are also provided.A signal l